Racereddie
New Member
Finally got all the pieces from ebay to install a Smartcraft Monitor. There are two system monitors, one is square and the other is round but they are the same inner working. The round monitor needs a 3 3/8" hole while the square one, (round in the back) needs a 2 1/8" hole so I went with that one. Once I decided that I was going to only use that single monitor I researched that I did not HAVE to have the junction box or caps I just needs a single cable (read also as less money) with terminal resistors on both ends (84-879982T20). For this cable the #2 before the "T" means it has 2 resistors, the 20 after the "T" tells you that it is 20ft long. Reading the 240hp EFI manual and other manuals I found online I was able to figure exactly where the cable connected to the engine. I will post pictures of the process.
Eddie
Eddie
Last edited by a moderator: