Water line clamp

[drvred]

Where , and with what do you clamp the water line if you have to tow your ski?
I have a GSXL with a 951.

 

[Coastiejoe]

The line from the pump to the engine. Many places sell "line clamps". Or "pinch off clamps".

Here are two styles.

 

[drvred]

Is that the line with the tee going to what looks like a rave valve?
Someone has removed the flushing tee and put a new hose there.

 

[Mickirig1]

Look on top of engine where lines are connected. Should have an line in and line out arrow cast in the head. Do a wrap of silver duct tape around it at both ends. Write "clamp here" with marker, so if family members have to tow. I have little vice grips already adjusted to work in a zip lock baggie. In the small storage under seat section. Wrap lanyard and key around clamp. So you don't forget it's clamped. Been there, done that!

 

[Spimothy Leary]

Look on top of engine where lines are connected. Should have an line in and line out arrow cast in the head. Do a wrap of silver duct tape around it at both ends. Write "clamp here" with marker, so if family members have to tow. I have little vice grips already adjusted to work in a zip lock baggie. In the small storage under seat section. Wrap lanyard and key around clamp. So you don't forget it's clamped. Been there, done that!

I did the exact same thing on my old ski, but one thing I learned was that I needed to rust proof those vice grips, when I eventually needed them (to pull a piece of a hat out of the pump/impeller) I found them rusted shut....

Thats when i switched to the clamps that were coated, (and bought a new pair of vice grips and sprayed them with fluid film before bagging them up again)

 

[dieselndoo]

Put a ball valve