• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

97 GTX No Power

Status
Not open for further replies.

Momawnadon01

New Member
Hey guys and gals. Been looking all 9ver these forums and have found multiple posts like mine but not quite like mine and sorry if this subject is a dead horse.

What I've been doing: the ski turned over and then hydro locked on the 2nd attempt at starting before season started. I didnt know about hydrolocking so I replaced battery and solenoid. Same thing turned turned turned. Let go button. Pressed again and cachunk cachunk cachunk hydrolock instead. Pressed again and nothing. Absolute nothing. Tested starter. Starter died. Rebuild starter. Jump starter. Starter works now. Put back in ski. And now no power to any fuses /control panel. Tested fuses out of box and they tested good. I can jump the solenoid and get the starter to start in the ski. I'm guessing it's a loose ground wire somewhere? Can anyone point me in a direction. I'm guessing around and not finding much. Other than I'm fixing one problem and then getting another.
 
Check the 15amp fuse in the rear electrical box. Did you disconnect any Ground wires while removing the starter?
 

Attachments

  • 97 GTX.JPG
    97 GTX.JPG
    40.8 KB · Views: 2
Status
Not open for further replies.
Back
Top