3 inch pump extension kit for x4 hulls

[Jetskigoodies]

The 95 xp had a 3 inch extension many people have wanted to buy just the extension but you would need more to make it work.

So I just parted out a 95 xp.

You will get everything that is needed to make the extension work on a
93 -96 xp and sp spi and spx models from 94-99.

Kit includes
3 inch extension
Pump housing with venturi nozzle, no impeller you would just use your own or buy a nice aftermarket one for more acceleration. You will need this pump housing because the three tubes that go through the hull on your pump will not slide into the extension, the extension has those on it and the pump has an oring setup like the newer gsx and gtx pumps have.
Steering cable
Trim rod moulding
Drive shaft, I would need to know what model you have so I know if the shaft will need to have a groove cut with a lathe to support the carbon ring clip. This will need to be done on any model after 96.
Pump mount studs.

If you are considering doing this you will need all of the above. All of your original stuff is too short to accomodate the extension.

I will sell this kit for $225 shipped to anywhere in USA

I will post pictures tomorrow. If I do not get any interest in it I will be selling the items individually.
I will actually make more by selling the items individually but it will just take longer.

 

[1995hx]

The 95 xp had a 3 inch extension many people have wanted to buy just the extension but you would need more to make it work.

So I just parted out a 95 xp.

You will get everything that is needed to make the extension work on a
93 -96 xp and sp spi and spx models from 94-99.

Kit includes
3 inch extension
Pump housing with venturi nozzle, no impeller you would just use your own or buy a nice aftermarket one for more acceleration. You will need this pump housing because the three tubes that go through the hull on your pump will not slide into the extension, the extension has those on it and the pump has an oring setup like the newer gsx and gtx pumps have.
Steering cable
Trim rod moulding
Drive shaft, I would need to know what model you have so I know if the shaft will need to have a groove cut with a lathe to support the carbon ring clip. This will need to be done on any model after 96.
Pump mount studs.

If you are considering doing this you will need all of the above. All of your original stuff is too short to accomodate the extension.

I will sell this kit for $225 shipped to anywhere in USA

I will post pictures tomorrow. If I do not get any interest in it I will be selling the items individually.
I will actually make more by selling the items individually but it will just take longer.

If this came off a 717 the drive shaft is shorter than the 787 model you will need a longer drive shaft for a 787. Also the tubes are just threaded on the pump they will come off.

Sent from my C771 using Tapatalk 2