Search results

No holes. The area right where the arrow is pointing is lose and that is where the water is coming out of.

I have a water leak coming inside the ski. I have a 1997 GTX. Not sure what the area is called so I included a pic with a arrow going to the spot the water is coming in at. Appreciate any help.

Thanks for info. For it back on.

After replacing the carbon seal on my 1997 GTX I found this rubber plug that I think came out of the hole the shaft goes into. After some research I think it goes on the end of the shaft. Do I need to take everything back apart and put this on? Thanks

I bought 2 used 1097 GTX models. I noticed one has foam blocks in the front and the other does not. Is this an issue?

Replaced the 15 fuse then also replaced the rectifier as I had one on hand. Ski fired up ran fine no blown fuse. Tried it several different times no issue. Pulled it out of garage today and tilted it up to make it easier to fix some trailer lights. A little bit of water came out, pulled back in...

Sorry 1997 GTX

The rear of the ski took on a lot of water and the rear area that has a fuse also took on water. I did not realize this for a long time. Once I found this out I series everything out and the ski ran fine on the water hose. Took it to the lake got up to around 45 display showed 12v failing or...

The rave valves were super dirty and 1 had a melted top. After cleaning and replacing worn parts with new ones the ski runs like a top and everything lines up and works perfect. Thanks so much for the help.

Thanks for the info. Will check these.

New carbs were installed in May or June

This seems to be as close as I can get them to each other.

Here is my oil pump. How do I adjust it? Thanks

Can you give me a little more detail about this. This is my first jet ski. Thanks

Got it running 3000 rpms now. Will get it in water later this week to test. Thanks for the help.

Do I need to remove air box to get to idle adjustment?

I tried to adjust the low setting on the carb but it did not affect the rpms at all. I found on here the steps to set carb but not sure I did it right. I found and adjusted the screw with the T on it and nothing changed.

The carburetor was replaced with a new one.

I have a 1997 GTX that runs 1500 at idle on the trailer and 1100 in the water. It takes off fine but tops out at 3500 rpms. On the trailer it revs up fine. If I can catch a wake and get the ski out of the water it will take off and run fine. The ski has new carb, new fuel lines. I just had it in...