think I've cooked my engine

Note: This site contains eBay affiliate links for which SeaDooForum.com may be compensated
Status
Not open for further replies.

kevchappy

New Member
Looking for advice.think I might have knacked my seado 3d rfi.i was out on it with low oil but was trying to run it down so could be filled up with fresh new oil.well it worked quicker than expected and engine cut out out.got towed in and when got home put new oil in and crossed fingers, engine fired straight up first time.flushed out and tried a couple of more starts, no problems. Then I came on this forum and found out I'd put the wrong oil in.order seadoo fully synthetic, emptied oil and filled with the right one.startdd up and motor went nuts.think you call it leanrunaway. Haven't tried in water yet but hoping for any advice.sorry for going on but wanted to give as much info as possible
 
How does it run now ?
Have you tried it again ?
How does the engine sound?
Feel anything loose if you rotate the driveshaft by hand?
Any new noises?
How did you shut it down ?
 
Last edited by a moderator:
How does it run now ?
Have you tried it again ?
How does the engine sound?
Feel anything loose if you rotate the driveshaft by hand?
Any new noises?
How did you shut it down ?
Just had it out sunday and seems to be running fine . didn't push it to hard but no harsh noises or stutters.do these engines have a fuel cut off if oil runs to low?
 
Status
Not open for further replies.
Back
Top