• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

spark problem

Status
Not open for further replies.

bscheff20

New Member
changed out the cdi box, and ignition coil in my 94 580 xp and still no spark. Any one have any other suggestions where should i check the ground at?
 
if not new, they have tendency after yrs, of loosing the connection from wire inside the insulator, to the connector in the boot....double check the grounds and battery connections for not hav'n spark. You replaced everything, that should give you something..
 
yeah the battery new and should be good b/c it turns over just doesnt get any spark but ill check the grounds i mean i dont know what else it could be possibly the stop switch is bad. I changed the lanyard but that didnt work right so i just have a wire holding it together so it will turn over. when the lanyard is hooked up it doesnt do anything
 
That is crazy I also have a 94 xp with the same problem. Did you replace the cdi with a brand new one or was it used? I realy hope I can figure out my problem and yours.
 
Status
Not open for further replies.
Back
Top