nsoley
Member
90’s / 80’s two stroke models with the Plastic Spigot for the water intake coming off the jet pump…Mine had snapped clean off the pump.
Get a 1/4-18 NPT tap, clean up the hole, and replace the spigot with a new Aluminum one.
Not sure if its needed, but I did use one revolution of pipe tape to ensure good “fill” between male and female threads. Hopefully this helps someone in the future.
Get a 1/4-18 NPT tap, clean up the hole, and replace the spigot with a new Aluminum one.
Not sure if its needed, but I did use one revolution of pipe tape to ensure good “fill” between male and female threads. Hopefully this helps someone in the future.
