i just got a spx 96 trade my 500cc dirt bike for it not a machnic but ive been reading up on the pcw and know about the entire pcw and have turn a wench a time or 2. my qestion is when i got the ski it had the vts boot ripped off only thing left was the rubber the clamps where on. i feel that more water coming in then should. the shaft inside hull has all new parts, and looks like it should from the diagram have not took the boot off inside yet to check the seals from out of water running . waiting for the vts boot to come in to install frist, then see if its still the problem.
the amount of water , when i drop it and the water seemed fine, but did not look good for leak. started it up went about 5 ft then started plaining up once plained i throttled it out went around the island then back to land buy the boat ramp the trip was about 1/4 of a mile .water covered the hull up to the bottom of the batt. early that day i went out for a ride curised about 4 miles out then came back in a hurry and got back to the boat ramp and she had water in it, almost to the black cover would normally hould a air filter . i let it dry
i hope i gave enough info sombody steer my the right way
the amount of water , when i drop it and the water seemed fine, but did not look good for leak. started it up went about 5 ft then started plaining up once plained i throttled it out went around the island then back to land buy the boat ramp the trip was about 1/4 of a mile .water covered the hull up to the bottom of the batt. early that day i went out for a ride curised about 4 miles out then came back in a hurry and got back to the boat ramp and she had water in it, almost to the black cover would normally hould a air filter . i let it dry
i hope i gave enough info sombody steer my the right way
