Dr Honda Well-Known Member Nov 8, 2013 #26 Yep... it's fine. Put a little thread sealer on it... and run them in. With that said.... crossing an inch, to Metric thread never NORMALLY works. BUT, because of the taper, and the non-standard thread pitch... the 1/8 NPT to 10T works out.
Yep... it's fine. Put a little thread sealer on it... and run them in. With that said.... crossing an inch, to Metric thread never NORMALLY works. BUT, because of the taper, and the non-standard thread pitch... the 1/8 NPT to 10T works out.
