Masive Leak please help!

[Gerv01]

I'm new with seadoo boats so i dont' have all parts or termanology down.

I had my boat (1997 challenger 110ph) out this weekend with a bunch of friends, boat was working fine then maybe 30 minuts into it it just bogged right down! open the engin compartment and full of water! bring it to shore eventually drain all water out start it again and there is a little whole in a hose but more importantly watter pouring in from in between fly wheel guard and engin!

Any tips for repain? I'm pretty mechanically inclined so on a scale of 1 to 10, 10 being the most difficult how hard is this repair goign to be? also time wise? i'm going out of town for two weeks in two weeks and would like to have it fixed by then?

A couple of weeks ago my sister dropped the rope attached to the bow in the water and it got sucked up, wrapped around the shaft, we eventually went to shore got the boat out and took out the rope and it seemed to work fine. Any other problems i should be looking for?

Also jumped it off a rediculous wake last weekend would that have caused any of this damage?

 

[seadoosnipe]

Bilge pump?.......

You don't have a bilge pump? The bilge pump is suppose to be automatic, keep it from filling up!.......

The water is pouring in through your carbon seal ring. There are two "0" rings in that seal. You may only need to check the rubber boat or anything that may be loose.

On a one to 10, it's probably a 6 because you have to remove the pump to get to it........................:cheers:

BTW, jumping a wake will not cause this.

 

[Gerv01]

Bilge pump works it's just coming in WAY faster then it can pump it out! when you say remove the pump what do you mean by that and were is that located?