Marine switch wiring

[turbosl2]

Need some help. My sea doo has 4 wire switchs which I believe are single pole single throw SPST for most of the switchs except the Nav/anchor light. My question is the wiring doesn’t line up with any switch I can find. Any idea what the 4 post is for with the resistor does? I would think these are 3 wire switchs with 1 lamp but the 4 post throws me for a loop. I will repin the connector if needed.
Wiring diagram



I purchased a handful of 3 wire amd 4 wire switchs. These two to be exact.

https://newwiremarine.com/product/on-off-spst-dependent-lamp/

https://newwiremarine.com/product/on-off-spst-indep-lamp-switch-body/

They are not momentary unless it’s for the horn or engine start. I am confused as to the wiring. Are the switches all supposed to be momentary amd the VCM activates the signal (e.g lights…)

I did not purchase this one.

https://newwiremarine.com/product/on-off-spst-lighted-switch-body/

Wish I had something to go by but the previous owner hacked it all up with automotive switchs amd not a single switch works. All a hack job. I want to put it back normal but don’t care if I have to repin

Thanks

 

[DooGuy]

Sent you a couple more pics of the wiring diagram with better detail of the routing

 

[Mister Magoo]

The resistors are for the LED's. There are 2 ways to light them, thats why there are 2 resistors.

 

[turbosl2]

Sent you a couple more pics of the wiring diagram with better detail of the routing

I appreciate that very much!!!

 

[turbosl2]

The resistors are for the LED's. There are 2 ways to light them, thats why there are 2 resistors.

After i starred at the wiring diagram i noticed that. I appreciate the response