high speed adjustment setting

[seadooer]

I am in the process of trying to set my dual carbs for my 92 xp. The HSA screw in the front had the black caps on them which I accidentally broke one off but also found out that i was able to turn that screw a couple of times to fully close or a setting of 0. This apparently wasn't the setting originially as it did have some play in it. How do i get each of the HSA screws back to where it was. It ran fine last season at high speed but stalled if i let the throttle go at idle.
Thanks

 

[kustomkarl]

The correct setting for the High Speed screw is "0". The plastic cap allows you to adjust it just 1/4 turn. If the seadoo stalled at idle before then you need to turn up the idle so it won't stall. Be sure both carbs are in sync.

Karl

 

[All Things Custom]

:stupid:........................

 

[kustomkarl]

uh....you calling me stupid? I think I must have missed something....:ack: