Anyone install the "Trim Fix" module

[Ctash01]

I used a flat file and lot of in and out file some and then put back in ect. ect ect. in the directions it mentions that if it runs down and when you hit the up button that it doesnt pick it up not to worry that when the pump is pushing water it will grab and move the nozzel up. I hope so mine travles up and down great but when it goes to the bottom I have to just barley nudge it for it to grab.

I was in the same boat as you Diablo and wasnt sure it took me a while but it works great so far, just file a little at a time. If memory serves me correct it took off about 3 to 4 threads from the screw.

I have a copy of the worm gear instructions from Todd @ the trim fix, if you need them send me a PM with your email address and I will pass them along.

I really need the trim fix worm gear instructions if you still have them it would be appreciated thanks