rpm

I was having starting problems with my 97 Gti. I haven't worked on 2 strokes much and was having a hard time figuring is out. Would run good the first run but after shutting it down, would always have a hard time getting it to start again. Would always eventually fire up and then run good but...

I have a 1995xp, the previous owner put on a high compression head(185psi) and after market flame arrestors. He could never get it to run and I ended up buying it as a basket case. I went through it and fixed his mistimed rotary valve, rejetted the carbs and replaced the leaking crank seals that...

heys guys, went out they other week and flipped the ski. after that it started up fine no problems...shortly after that i shut it off and tried starting it again and it was pretty difficult. once it started it would bog if i gave it a little gas and almost die out until it reached about have...

Hello everyone... and thank you for viewing my first thread as I am new to this forum. I have an old 95 speedster with twin rotax engines that is still a lot of fun to take out on my smaller lake. I have come into a recent issue where if I don't ease into acceleration the engines will give out...

Hello all, and first, let me say thanks for some seriously funny AND informative posts. I'll try to be quick here. I am new to watercraft but have spent a lot of time working on cars. If it needs repar, I would always rather do it myself. Bought a 2009 RXT 215 that is gorgeous, 50 hours...

Have a 2006 RXT that we bought new. Upon starting, it wouldn't idle but if you gave it gas it would run fine and go right up to top speed (70). My son searched on-line and found directions for tightening cable for idle. He worked on it last night but we don't know what rpm the idle should be...

My Sea-Doo seems to be idling too low, and will eventually die if I don't use a little throttle. The RPMs are around 1400 after running it wide open, and then I can watch it steadily drop down to around 1000-1100 before it cuts off. I have read that there are some screws that can be adjusted...

I just bought a 1995 speedster and took it out for the first time. At low RPM, 3500, or less both engine show the same RPM and sound and feel like they have equal thrust. As I started to throttle up, the left engine would shoot to 6,000 to 7,000 rpm while the right was steadily working...

HI, I have a Seadoo Challenger 2000 from '03 ..My RPM counter has stoped working I have tried to find the problem by looking at the plug for the RPM counter but havent been able to find a solution. Do any of you have an idea of what to to? :bigear: Thanks in advance.. Jimmi

Hi starting to pull my hair out here hopefully somebody can help.. OK I've been over the boat cleaned the raves. Just had a local shop re-jet and set up the carbs (was told all is good in carb land) brand new, pump oil, impeller, pump bearings, wear ring. I checked the fuel selector valve which...

hi there been doing a lot of reading on here and trying to see if I can fix an ongoing issue with my ski.I was hoping to get some info from ya... I have 2 96 gtx's 1 was running begining yr. then wouldn't run in water... did compression check found pistons where toast... had them replaced, and...

Does anyone out there have a 2010 challenger 210 that both motors run at the same RPMs? Does your SYNC light show in your right tachometer? If the RPMs don't match...does the boat atleast go straight? I recently bought a 210SE 430HP nd having the same problem a few people already seemed to have...

I have a 1998 Speedster. Yesterday while operating I started to get inconsistent revving of the port engine. Engines start with no problem. After warm up, rev both up to get to plane. Starboard engine goes to 5,500 RPM, port engine gets to 4,000 RPM and stays there. Then I get bursts of...

In the Tech Manuals I see reference to 4 x 0.138" holes that feed open circuit cooling water into the exhaust gas (This is the lake water fed by the jet pump to cool the intercooler, inlet manifold, exhaust muffler and exhaust gas, not the closed circuit coolant that is pumped through the drive...

To build off an earlier thread, my ski runs great at low RPM's. At about and over 3/8 throttle, the ski pops, at the same time the ski stops pushing. This lasts only 1 second and the ski continues as normal. This happens at random but on average ever 3 seconds or so, regardless of what the High...

Ever since I bought this ski, I have had issues with it. I have changed out the starter motor twice and been through a ton of batteries troubleshooting. Anyway...now that I got all that done, it only seems to run well at low RPM's, about half throttle. After that point, I can hear a popping...

Hey everyone last weekend I took the GSX out to the lake for the first time this year... This happened http://www.seadooforum.com/showthread.php?p=113914#post113914 Long story short in that thread, hull filled up about 1/3 of the way with water, got it all drained within 5 minutes and...

Hi, I've just registered on the forum, but have read around site in the past for help. I have a few issues with my 1996 Seadoo GTX (787cc engine) which i will list below. My first issue is a revving problem. Some possibly related background: I recently took off the carbs and choke...

1998 sportser 1800 Hello I recently purchased a 98 sporter 1800 I replaced both starters on the twin engines. I was running full throttle when I noticed the starboard engine rpm up around 7000 while the port was running around 5800. please advise any suggestions. thanks Ed

OK, I hope someone can help me out here, This problem occurs only at top end. Everything runs ok at idle and midrange. Will only run aprox. 25 mph as opposed to 40 that it use to run. I've dis-assembled the carb, cleaned it, and put it back on. That did nothing. I then took a carb off my...