exkartracer
Member
Hello, I'm considering installing a VTS trim system on my 2006 3D Di. I'm not interested in installing a gauge. Just a button and motor at the nozzle. I was hoping to swap over parts from an XP Di, as these have the same hull. The schematics I have show the VTS system wired into the MPEM for a 2004 XP Di. I was hoping to hook up a separate system, with just the hardware from an XP.
Any suggestions are appreciated. I have broken two of these manual trim screws on the 3D. Any source for used parts is appreciated as well. Is this project even feasible? Are there any other options for trim control, like a cable and lever?
Thank you for the help, this is a great forum.
Any suggestions are appreciated. I have broken two of these manual trim screws on the 3D. Any source for used parts is appreciated as well. Is this project even feasible? Are there any other options for trim control, like a cable and lever?
Thank you for the help, this is a great forum.