Search results

New paddle sensor and used speedometer. Decided to go with GPS-easier install. 100$

In great shape fits sport jet 175 to 240, came off a 240. Comes with cobra jet steering fins. No rust, repainted Bought Posi steering nozzle, these are not needed 180$

Did you figure out the issue?

Did you ever put on that trim extension plate? Do you notice a difference?

What’s your email address, I will send you the service manual

Also the intake manifold temperature also check the fuses just above the red battery cable on lower starboard side, with the arcing happening maybe a fuse blew.

Looking through the service manual, continuous beep is cause by the following Cooling system- any water coming out of the pisser hose? Could be an obstruction, I backflushed my system - output to pisser I put a water line there and ran back through, some small debris came out. Oil level...

Hi All, Hope you can help, fuel injected 2003 M2 240HP second generation on an Islandia. I have read through the forum posts here, I see others have had this issue but I don’t see a resolution. Starts great cold, run great through all ranges. Pulling a tube running her hard, shut down the...

Hi All 2003 Islandia. Second generation, electric oil pump. Took the boat out, ran great through all rpm ranges no issues. Took the kids on the tube, slowed down to pull them in, shut down the engine, loaded them up. Went to restart, it would not start. Started seeing lots of white smoke...

Hope someone can help. 2003 engine coolant temperature port fault- replace with new sensor- it was the metal not the plastic type. It still throws the error code just like the original. It does white smoke for 30 seconds and goes away. It is also throwing a code Intake manifold air...

Hi all Trying to figure out how the front Bimini is stored when the cover is on. If I remove the front posts from the boat holders, fold them in and then pivot the back ones so the whole Bimini lays down toward the front, it is not a nice fit and crushes into the navigation lights- seems like...

Mine is too, seems confusing why it has threads, service manual shows it like that too.

That’s the bilge siphon hose. I asked the same question when I got mine! The jet creates a suction through that hose to keep the bilge free of water- like an extra bilge pump. Zip tie the middle section to the top of the expansion chamber and lay the other portion in the lowest part of the boat.

Thanks!

Can anyone please take a look at their boat and tell me where that tube connects? It terminates somewhere on the starboard side. Really appreciate it thats great, thanks I appreciate the response! I was a little worried- I did find the hose laying on the bottom of the bilge but it had a...

Can anyone please take a look at their boat and tell me where that tube connects? It terminates somewhere on the starboard side. Really appreciate it!!

Hi all, First time post, just bought an Islandia and am restoring it. Today I was cleaning the bilge and I found this water line with a filter and a fitting with loctight on it, just laying on the floor. Any idea where is goes? Looking at the service manual, it does not show this water line...