• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Turbine not functioning

Status
Not open for further replies.

jimmyg88

New Member
Finally got my boat on a good lake and opened her up. The port engine hits 8000 rpm while starboard tops out at 6000. I also noticed no turbine whine on the starboard engine but engine seems to run ok just not as powerful. Any suggestions.
Thanks
Jim
 
Finally got my boat on a good lake and opened her up. The port engine hits 8000 rpm while starboard tops out at 6000. I also noticed no turbine whine on the starboard engine but engine seems to run ok just not as powerful. Any suggestions.
Thanks
Jim

If it is super charged check your intake hose for cracks or to see if one came off.
 
Hose looks ok, The engine only has 50 hours on it. Could the wear rings be worn already? Just purchased it from a dealer
 
you can always pull the intake off the super without it running of course and stick your hand in and see if you can spin the fan. if it spins you have a super problem if you can't move it then you should be able to rule that out.
 
means that your super should be working fine and your clutch washers and needle bearings are all still in place. if that was your concern then you shouldn't have to worry about that. make sure you get it serviced every 100 hours like you're suppose to.
 
Status
Not open for further replies.
Back
Top