So I'm a newb to my Seadoo (95 GTX) and would appreciate any help/advise. Like the title says, I'm trying to get my drive shaft out. I already took off the the pump housing so that the shaft is the only thing sticking out. I can't just pull the shaft out the back because of the stuff attached to it on the inside. So how am I supposed to get it out? Thanks you for your help.
-
This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.
Trying to get drive shaft out....
- Thread starter slprdsm
- Start date
- Status
shaft removal......?
Unless your shaft is seized in the PTO hub, it's a pretty simple procedure.
Remove the rubber boot at the PTO hub (squeeze the two tits of the clamp together to loosen with a pair of needle nose pliers). Then, loosen the clamp at the carrier seal. If nothing is seized together, the shaft should now just slide through the back of the craft.
Unless your shaft is seized in the PTO hub, it's a pretty simple procedure.
Remove the rubber boot at the PTO hub (squeeze the two tits of the clamp together to loosen with a pair of needle nose pliers). Then, loosen the clamp at the carrier seal. If nothing is seized together, the shaft should now just slide through the back of the craft.
- Status
