Supercharger compressor base plate ruined?

[Salraso]

Hello all I’m in the process of rebuilding my supercharger for my 2007 rxt 215
Well the 4 pin locking nut was super stuck on there that it broke my tool making me slip and knick the compressor base plate, not horrible but it’s there I took the edge off of it so there is no sharp edges just the indent, would you guys run it? Will it be fine?

 

[ski-d00]

Take a stone to that nick to make sure it isn't standing pround and it will be fine. That area of the housing has very very little to do with the air flow path.

 

[Salraso]

Take a stone to that nick to make sure it isn't standing pround and it will be fine. That area of the housing has very very little to do with the air flow path.

Thanks this is what I ended up doing seems good doesn’t contact the turbine at all should be good!