Moejay
Member
I received my Stryker rod holders after a 5 week wait. It was advertised as fitting a 1 3/4" beam but what I received was a
2 1/16" holder. My question is what size are the front and rear beams on the 2012 speedster 150 tower?
I measured circumference and calculated them as 1 7/8" and 2 3/8"...is this right.
I need to know to have the rod holders bored a bit to fit the larger beam or for some rubber for the smaller beam.
Thanks,
MJ
2 1/16" holder. My question is what size are the front and rear beams on the 2012 speedster 150 tower?
I measured circumference and calculated them as 1 7/8" and 2 3/8"...is this right.
I need to know to have the rod holders bored a bit to fit the larger beam or for some rubber for the smaller beam.
Thanks,
MJ
