• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

seadoo speedster SK MPEM wiring

Status
Not open for further replies.

redlion

New Member
I have a 2000 speedster and wanted to check my wiring to the MPEM. i knocked a couple of wires off when I was cleaning it and not sure they are back in the right place.

They are numbered 1 - 16 in 2 banks.

1-8 look correct but not sure of 9-16. there are only a few wires connected.

can anyone share a list of number and wire colors or a picture ?

thanks.
 
I assume you mean the fuse block? In 2K, the Speedsters had the Mercury engine, no MPEM in that boat if I recall properly. Just going off my memory, I could be completely wrong.

Hopefully someone can snag a pic for you.
 
yes, its a fuse block, black with two rows of fuses. the incoming / outgoing wiring looks like they clip to spades on a circuit board inside the plastic housing.

it is located just in front of the steering wheel in the storage well.
 
This picture is the fuse block. It has connectors 1-16 on it. I'm looking for a wiring diagram for it.

FUSE BLOCK
204470470
 

Attachments

  • IMG_0685.JPG
    IMG_0685.JPG
    141 KB · Views: 7
I still couldn't find a wiring diagram so I belled it out and figured out which fuses related to which contacts. Certainly not obvious but I had the power on the wrong pin and therefore no power to the radio or the 12v outlet.

All sorted now.

Thanks.
 
Status
Not open for further replies.
Back
Top