• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

SeaDoo Safety Switch & Lanyard NON-DESS SP SPI SPX XP GT GTS GTX 1989-1995

Status
Not open for further replies.
Neither one of my kill switches are working on my early 90s SP. The lanyard must be attached to start, but wont die when pulled. The kill switch at handlebars wont kill it either. I must choke it to kill it. I tried swapping the switch and MPEM with a parts seadoo and had the same results. I guess it's possible both MPEMs are bad but I dont believe it's the switches. I by passed both switches and just connected/disconnected wires and had same results. (Lanyard normally open and handlebar killswitch normally closed). Any ideas or suggestions or is it most likely I need a new MPEM? All the grounds look good and fuses are good.
 
Status
Not open for further replies.
Back
Top