MN Sea Doo Boater
New Member
I have a 1998 Speedster. Yesterday while operating I started to get inconsistent revving of the port engine.
Engines start with no problem. After warm up, rev both up to get to plane. Starboard engine goes to 5,500 RPM, port engine gets to 4,000 RPM and stays there. Then I get bursts of acceleration as the engine revs up, then quickly revs down below 3,000, then to 4,000, then up, then down, etc.
I thought at first it was a bad switch (per another thread), but neither engine starts in forward, and it does exceed 4,000 before dropping.
I searched the site but not hits on a problem like this.
The boat was tuned before putting into water and run less than 5 hours since then.
Any suggestions?
Engines start with no problem. After warm up, rev both up to get to plane. Starboard engine goes to 5,500 RPM, port engine gets to 4,000 RPM and stays there. Then I get bursts of acceleration as the engine revs up, then quickly revs down below 3,000, then to 4,000, then up, then down, etc.
I thought at first it was a bad switch (per another thread), but neither engine starts in forward, and it does exceed 4,000 before dropping.
I searched the site but not hits on a problem like this.
The boat was tuned before putting into water and run less than 5 hours since then.
Any suggestions?
