• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

quick questions

Status
Not open for further replies.

bond67

New Member
ontop of the oil tank on the 96 gtx there is a T that looks like there is a line going towards the engine but the part facing the front doesnt have a line or hose on it, i would post pic but cant find card adapter. is there suppose to be a line on there

also can i run the engine without the intake box on it for just a few secondss?
 
The other side of the T should be connected to a check valve that vents to the outside of the hull.Yes you can run it without the flame arrestor for a short period of time but it can cause a lean condition so I would do it for long.
 
Actually on the oil tank, there is only a short 2 inch hose with a check valve on the end.

Chester
 
should anything be connected to that check valve?

where is the oil filter?

Ive done

Spark plugs
Replaced fuel lines
cleaned gas filter up front
cleaned carb filters
I'll grease the shaft when I get grease for the grease gun
WD-40 a lot of the compenents in the hull (is there any other than wd-40 i should be spraying in there?)

is there anything else I should do to the ski?

Also I noticed one of the butterlies was off like 1/16 or so from the other one, is this a big deal?

I'll probably rebuild the carbs during the offseason
 
Last edited by a moderator:
1 more quick stupid question before i go to oreillys, do i have to use the synthetic grease on the pto or can i use the marine grease that oreilly's sell
 
Status
Not open for further replies.
Back
Top