• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Problem with oil sensor????? RXP

Status
Not open for further replies.

jumpthatwave

New Member
Hi... I recently purchased a 2004 Sea doo RXP.. I put it in the water and went out for a spin , as i was riding i felt a jerk and oil light started to flash.. I turned ski off then back on so that beeping sound would stop.. i was able to idle my way back to the marina but as soon as i give a little throttle the oil light comes on and the beeping, jerking continues.

I also jumped a wave and as soon as i land the ski sort of chokes at the landing then after a few seconds it catches back(this was happening prior to the oil light...

Any help will be highly appreciated ..

Thank you
 
Check the oil level. If the oil is fine it could be the sender going bad, and causing the seadoo to go into limp mode if it looses oil pressure from a mechanical problem or a bad sensor. Is it throwing any trouble codes?

Karl
 
Status
Not open for further replies.
Back
Top