Colseadoo1955
Active Member
My 1997 Seadoo GSI will not start. It is the 1st time putting it in the water after purchasing it cheap and replacing the red start stop switch and lanyard switch. I hooked up a hose in my garage and it started and ran great there.
it had a loose hose where the aftermarket garden hose tee was installed and about 5 to 6 inches of water got in the bilge before I caught it. As you face the MPEC box the third fuse from the bottom (7.5 amp) was blown. As soon as I plugged in another fuse it immediately blew, too. I cannot seem to find a decent diagram online showing that circuit.
advice on how to proceed appreciated.
it had a loose hose where the aftermarket garden hose tee was installed and about 5 to 6 inches of water got in the bilge before I caught it. As you face the MPEC box the third fuse from the bottom (7.5 amp) was blown. As soon as I plugged in another fuse it immediately blew, too. I cannot seem to find a decent diagram online showing that circuit.
advice on how to proceed appreciated.
