Jet Pump Alignment

[rldavis]

Anyone out there know where I can get a procedure on the jet pump alignment. I read a post where they should face inward a certain amount and would like to know how to determine this. My speedster is pulling to the left and I am thinking this is the issue. Already checked wear ring and impeller and both check good.

 

[gazzaskirepair]

Not the jet pump but the Jet nozzle

 

[MacSeaDoo]

What year is your boat?

 

[rldavis]

What year is your boat?

07 speedster wake, also how did you find your inter cooler leak? I’m thinking I might have same issue.

 

[MacSeaDoo]

I pulled the intercooler out and pressurized it with my compressor. I think yours is a 215HP which I believe has the IC in the center of your intake manifold. I couldn't hold anything pressure wise.

 

[JPass]

If you're talking about the nozzle, I would think laying a straight edge across the face of the nozzle, with the steering wheel centered, and measuring back to the hull on both sides of the straight edge would do it.

 

[rldavis]

I pulled the intercooler out and pressurized it with my compressor. I think yours is a 215HP which I believe has the IC in the center of your intake manifold. I couldn't hold anything pressure wise.

That adaptor looks like something I would make LOL. I am concerned about the intercooler after I changed the plugs, it may just be carbon on the port side plugs but there is a difference for sure. This is the first time I have changed them so not sure if they changed starboard motor and left the port side alone and that is the big difference. Nonetheless I guess I I can pull it out and check. Doesn't look to complicated and as you mentioned it is in the center intake manifold. Thanks...

 

[rldavis]

If you're talking about the nozzle, I would think laying a straight edge across the face of the nozzle, with the steering wheel centered, and measuring back to the hull on both sides of the straight edge would do it.

Yes the nozzle. So if I took a straight edge across the center of both nozzles should it touch the straight edge in four places or the two outside edges? I read some where that they should face inward slightly.

 

[MacSeaDoo]

1.Get your steering wheel straight. (easier with 2 people)
2.. Align as per below with the starboard pump.
3.. Once that is straight, adjust the nozzle steering link to do the same with the port side.