I have a 2017 RTX 260, replacing the wear ring. My impeller came off by hand, all videos I see shows a tool needed and hard to remove. Everything looks good, shaft spins freely, bearings make no noise. Reinstall the impeller without tightening and spins perfectly. When I tighten with a socket just holding the impeller I am unable to spin it any longer. In videos when reinstalling in the ski it shows turning a bit to line up splines but I am unable to do that unless I leave it only hand tight. What am I missing? Any help is greatly appreciated.
-
This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.
Impeller Install
- Thread starter CLEIGH
- Start date
Similar threads
- Locked