gas guage not working

[srizzo]

My gas guage suddenly stopped working. It is not lit up at all. Ay suggestions on where to look to fix this? Perhaps something was disconnected, fuse blown - or god forbid - a baffel problem???

 

[JPX]

High probability of a baffle/sender problem. Low probability of bad gauge.

 

[Nate Surveyor]

I go with the "baffling" problem!:agree:


(bad pun, but look around here. There are answers to the baffle too)

Nate

 

[JPX]

Fuel baffle link->http://www.seadooforum.com/showthread.php?t=5826

 

[KaosIND]

I have one question about the whole gauge thing shouldn't you still have some lights on the gauge even if the baffle is bad. I would think the oil temp and batt lights should still light up when starting or holding button for a few. could the problem be the MEPM or does the power not come from that?

James

 

[JPX]

Check fuses then......MPEM box, they are under rubber boots. And check the ignition box as well for a fuse in there (I think).

 

[KaosIND]

The only reason I ask is I have a SPX with a non working gauge. I tested the Baffle and its fine I took the gauge out and hooked it up to my other SPX and it works. All the fuses on the MPEM are OK. could the MPEm be bad. everything else works fine it fires up and runs great just no gauge?