• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Challenger 2000 Trailer measurements

Status
Not open for further replies.
I recently bought a 2001 Challenger 200 that is in perfect running condition now after replacing the TPS. But I noticed it is hard to get on the trailer straight... Then I remembered that the trailer is quite a bit newer than the boat and therefore is not the trailer that was for the boat. I got to looking with the boat out of the water that the trailer rails are not in the right spot...

was wondering if anyone knew the correct measurements (spread, height ) on the 4 trailer rails? and a good way to lift the boat? even pic from the back that shows the rails placement on the hull would be nice...


Thank you .
 
I recently bought a 2001 Challenger 200 that is in perfect running condition now after replacing the TPS. But I noticed it is hard to get on the trailer straight... Then I remembered that the trailer is quite a bit newer than the boat and therefore is not the trailer that was for the boat. I got to looking with the boat out of the water that the trailer rails are not in the right spot...

was wondering if anyone knew the correct measurements (spread, height ) on the 4 trailer rails? and a good way to lift the boat? even pic from the back that shows the rails placement on the hull would be nice...


Thank you .
If you get no other replies I can take a pic of mine, but I won’t be near it to take a pic for three weeks (mine’s a 2000, but I assume identical). However, I believe my trailer has only two rails, so not sure how useful it would be. It is the original trailer for the boat.
 
Status
Not open for further replies.
Back
Top