• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

bleed system solved :) new question

Status
Not open for further replies.

atlantis6

New Member
on the bottom near the intake there are 2 screws.

i discoverd that it was to lubricate something.

Is there a special tool needed to fill it up.


Any help welcome :)
 
on the bottom near the intake there are 2 screws. i discoverd that it was to lubricate something. Is there a special tool needed to fill it up.

Those are the fill and vent ports for the front lube in the jetdrive. Mercury sells their "High Performance Gear Lube Plus" for that, and a nifty little hand pump that screws right into the bottle on one end and straight into the center port on the other, to fill 'er up.
 
Any Mercury shop. In fact, most places that sell the lube I mentioned will also sell the pump that goes with it. Around $10, and it lasts forever.
 
pump & lube.pngw9 adapter.jpgmaybe in the states but here in europe always problems :) i can't imagine that they will have it.

but no problem i found it on internet for 20 $ including pump.

i think it wil be faster then ordering here in the store.

i foud these see picture.

do i need the adapter olso
 
Last edited by a moderator:
Status
Not open for further replies.
Back
Top