glen young
New Member
Can you block off the pump and do a premix on a RFI engine?
The reason I ask is my old enging through a rod and I just replace it with a SBT engine and after I bleeded the oil line from the oil tank to the pump and was trying to prime the two feeder lines to the rotor vaule. I notice no oil coming from the pump to the rotor vaule. ( the reason the old engine through a rod) I'm guessing bad pump, I haven't taking the pump off to check it. But with no oil coming from the pump when I would spend the engine with out plugs in so the engine would spend faster and I would wot the throtler, ( I haven't connected the coil and plugs wire yet and no gas in the tank), I'm not getting and oil from the pump.
any ideas from any of you all?
thanks, Glen
The reason I ask is my old enging through a rod and I just replace it with a SBT engine and after I bleeded the oil line from the oil tank to the pump and was trying to prime the two feeder lines to the rotor vaule. I notice no oil coming from the pump to the rotor vaule. ( the reason the old engine through a rod) I'm guessing bad pump, I haven't taking the pump off to check it. But with no oil coming from the pump when I would spend the engine with out plugs in so the engine would spend faster and I would wot the throtler, ( I haven't connected the coil and plugs wire yet and no gas in the tank), I'm not getting and oil from the pump.
any ideas from any of you all?
thanks, Glen
