• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

2010 challenger 2010 wiring

Status
Not open for further replies.

rsofonio

New Member
looking for wiring diagrams, my volt gauge is stuck on peg. not sure if gauge is defective or wiring to it is.
Charging system is ok and charging the batteries.
but before going further need to know if the shop manual will have the electrical wiring included.
Thanks
 
Tested the boat out today and the gauge was reading 10 to 12 volts. But on battery terminal about 14.3 volts. Need to figure out what is going on.
Where did u get the wiring diagram booklet.
On this site it seems like only shop manual r available .
Thanks
 
Tested the boat out today and the gauge was reading 10 to 12 volts. But on battery terminal about 14.3 volts. Need to figure out what is going on.
Where did u get the wiring diagram booklet.
On this site it seems like only shop manual r available .
Thanks
I don't have the wiring diagram booklet, but I did see it offered on eBay.
 
Take a volt meter and see what it reads on the back of the gauge. My gauge reads 0 but the meter shows correct voltage. Ordered new gauge tonight. Expensive but need the piece of mind.
 
Status
Not open for further replies.
Back
Top