2008 Wake Pro 215 VTS Motor Cover Fell off?

[mlamanne]

Hi, I just bought a 2008 Wake Pro 215 and notice that the VTS Motor Cover has fallen off. I tried to put it back on but I am not sure how it is suppose to lock on to the VTS Motor Box. The cover has 3 tabs and They are all there, the box has three coresponding areas that the tais go into but there sin't any way for these tans to gras and hold onto the box.

Does anyone know how the VTS Cover is Held onto the box? Does it somehow just need to be tape back on with a hammer or something?

 

[ski-d00]

The rubber seal goes on the box, not in the groove of the lid. Dig it out of the lid and put it on the box, then the lid will go on properly but be careful to make sure each tab is going into each slot evenly until it snaps into position for all 3 tabs.

 

[mlamanne]

The rubber seal goes on the box, not in the groove of the lid. Dig it out of the lid and put it on the box, then the lid will go on properly but be careful to make sure each tab is going into each slot evenly until it snaps into position for all 3 tabs.

Thanks for the reply. That must be my mistake then as I was forcing the gasket into the groove on the cover.

 

[mlamanne]

Awesome, I just put it on properly and fits like a glove. Thanks again.

Mike