pdjurovich
New Member
2008 4-Tec Engine Repair
Had a supercharger let go when the nut, 16 tooth gear and washers came of and went in the engine. Pulled out most parts and will have to replace a few parts. Is it easy to pull off the engine base to remove any damaged parts inside. Just want to see if the crank bearings are OK and after cleaning the engine base is it simply a matter of fitting a new gasket and reverse assembly? Any tips
Had a supercharger let go when the nut, 16 tooth gear and washers came of and went in the engine. Pulled out most parts and will have to replace a few parts. Is it easy to pull off the engine base to remove any damaged parts inside. Just want to see if the crank bearings are OK and after cleaning the engine base is it simply a matter of fitting a new gasket and reverse assembly? Any tips
Last edited by a moderator:
