I am trying to find out how to flush the 155 Rotax engines. My boat has a pipe on the left side of both engines in the back beside what I will call the jets. It appears they are threaded inside on the end so I am thinking I need those adaptors to screw in there and use the kit to hook up the hose. Also can I flush one engine at a time or do I need to make a hose connection to do both at the same time? We are taking this boat to the beach where it will be in the ocean and taken out each time that is when I need to flush. Also I am told in 2006 they built two different engine configurations A and B but so far no one can tell me the difference so I know which one I have. No one in my area knows anything about these boats. I have watched videos on changing the oil by extraction I want to get that done also before taking it down to the beach. Sorry for the long thread I just really know nothing either about the boat other than it being a blast on the water.
-
This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.
2006 SeaDoo Utopia with Twin 155 Rotax Engines Non-Supercharged.?
- Thread starter KDUB1959
- Start date
- Status
Thank you so the hookup is that pipe beside each out drive?
briancayko
Active Member
Correct. It will have threads for a garden hose to connect so you can’t really get it wrong. Just make sure you start the motor then turn on water. Then turn off water before shutting off the motor in that sequence.
Yes Sir I do appreciate it. I screwed one of the adaptors in today at lunch. I am going to change the oil and filter tomorrow and I am told to warm up the engines a little before extracting the oil from the dip stick hole I also by watching you tube found out how to get that done so I purchased all that is needed there also. Thanks again for your help
- Status
Similar threads
