lilngineer
Well-Known Member
Hi,
I am having some cavitation issues during the hole shot with my boat. Today I pulled to pumps for wear ring service and noticed that my wear rings were not very worn at all. The greatest clearance is .012"
I did however notice that the forks on my weedless intake grates seem to be bent a bit. Can anyone get me a picture of the bottom of the boat looking up into the pumps for this boat? I am trying to figure out if they need to follow the profile of the hull or not.
Also upon removal, all 4 philips screws attaching the grates broke off in the hull. Any advice on how to get the remainder of the screws out? Easy out maybe?
Any help is greatly appreciated!
I am having some cavitation issues during the hole shot with my boat. Today I pulled to pumps for wear ring service and noticed that my wear rings were not very worn at all. The greatest clearance is .012"
I did however notice that the forks on my weedless intake grates seem to be bent a bit. Can anyone get me a picture of the bottom of the boat looking up into the pumps for this boat? I am trying to figure out if they need to follow the profile of the hull or not.
Also upon removal, all 4 philips screws attaching the grates broke off in the hull. Any advice on how to get the remainder of the screws out? Easy out maybe?
Any help is greatly appreciated!
