• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

2004 1800 Challenger Ignition problem

Status
Not open for further replies.

qk03cobra

New Member
Does anyone have a photo of the way the ignition is wired or in that matter all the electrical under the storage container behind the gauges? I have some wires that are not plugged in and was wondering if this is causing my problem. My ignition is not turning off when I turn the key off. I just installed a tower and think I blew a fuse or unplugged something. My gauges are also not working. The boat does run though so I was able to test the wake tower and am impressed with the Joystick signature tower!!
 
Last edited by a moderator:
Does anyone have this same boat that could take a photo for me please? Want to make sure everything is connected correctly.
 
2004???


Do you have a mercury engine in it? if so... what one? But, if you do have a Merc, you are in the wrong section, and I will move it.


Also... pictures of electronics don't normally help fix anything since you can see where the wires are going.

With that said... and assuming you have a Merc... look for a black wire with a yellow trace. That's the kill wire. Make sure it's hooked up behind the key, and at the ignition back at the engine... and that the wire isn't cut.
 
Status
Not open for further replies.
Back
Top