• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

2003 merc 250.. how to.. jet pump

123indyrt

Active Member
Need to disassemble the rear "cone_vein" to replace the bushings. There is a large nut. Tried a 2ft pipe wrench to no avail
 
on my 2001, the seal popped right out. New seal popped right in.
Inner seal? The new one is not very flexible. I believe THAT is the seal causing my oil leak. The outer is some sort of retention part...

There's so little info online for these.. sucks
 
OMG...

After searching high n low on the internet, downloading a manual that told me I need a special seal puller, it flicked RIGHT OUT.

THERE ARE NO TRICKS... IM SO happy yet so pissed I couldn't find this info. I've missed weeks of boating smh

Thanks for the input guys
 
Back
Top