• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

1999 seadoo speedster stoped and wouldn't start

Status
Not open for further replies.

abouels0827

New Member
Hey I was out for the third time this year....everything was good till I decided to stop turn both motomotors off n float for a lil...when I went to fire up they wouk d start...after teying with no result I rhought I ran out of gas...so I got towed back...went to gas station but it still wouldn't startd...found out I had no spark so I jiggled the wires a little and boom they started right up....so is this a ground connection that is loose or what?
 
Thanks dr honda...I can always count on u...any ideas where it would be or should I just follow all wires and tighten everything up.
 
From where I'm sitting... it's hard to tell. There wasn't a common issue. I would start with the main power/ground cables.
 
IF "jiggled wires" means jiggled the plug wires / boots, then I would check the plug wires to the boot.. They may have bad connection in the boot itself.. Maybe Honda can verify, but should be able to turn those boots off cut the wire back a 1/4 or so and reconnect to plug boot.
 
Status
Not open for further replies.
Back
Top