• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

1995 speedster mpem blowing fuses

Status
Not open for further replies.

danfield

New Member
I have a 1995 speedster that was running fine, but I went to use it a couple days later the MPEM fuses keep blowing, anybody know what the problem is, thanks
 
Salt water got into something. Pull the stator covers, electrical panel cover, etc and see where the water pours out of. You could try putting larger fuses in, but its not recommended. If you try that, dont exceed 5 amps over OEM, or you could fry the wiring.
 
I unplug the large connector out of panel and the fuses keep blowing, unplugged the vol. reg. and I was able to keep 3amp fuses in MPEM, pluged large conector back in and fuses blow, so I unplugged connector at stators and fuses did not blow, what do I need stator and vol. regulators, thanks
 
well just plugged all connector back in , one at a time, all ok until I plugged the port engine plug back in and blow both 5amp main mpem fuses, do I just need the stator in the port engine, thanks
 
both engine are running fine now, can I check if their is water in their, with the engine in the boat, if so how, thanks
 
Status
Not open for further replies.
Back
Top