1994 speedster driveshaft removal

[nomer0220]

I have a seized bearing on one of my drive shafts and need to change it out. Is there any threads or how to's on removing the driveshaft?

Also what other wearable parts should I replace while doing this?

Any help would greatly be appreciated!

 

[Dr Honda]

If the bearing is rusted to the driveshaft... then you may have to cut it... and replace all of it.

Even if you break the bearing lose, and get it to slide out... the inner bearing race, is the driveshaft. So, if it's rough... you can't reuse the dirveshaft anyway.

 

[nomer0220]

If the bearing is rusted to the driveshaft... then you may have to cut it... and replace all of it.

Even if you break the bearing lose, and get it to slide out... the inner bearing race, is the driveshaft. So, if it's rough... you can't reuse the dirveshaft anyway.

I get that but at this point I'm just trying to figure out how to get the drive shaft out...I'm just trying to find out how to remove the pump, any clips or step by step instructions.. just any advice so I'm not going in blind on this repair

 

[rjcress]

Search is your friend.
This thread may be helpful: http://www.seadooforum.com/showthread.php?61231-Drive-Shaft-Removal&highlight=remove+drive+shaft

This one has good instructions also: http://www.seadooforum.com/showthre...g-Your-Wear-Ring&highlight=remove+drive+shaft

And the manual gives a nice step by step...