Search results

No performance gain, Just keeps a preload on the pump shaft to minimize the typical rattle sea-doo's are known for when you hear them running out of the water or on a flush.

Rave Valve cleaning.

If you loop the oil line, its typical and common practice that a 3" Gap if left for expansion. This will be fine. Racers have been doing this for years.;)

:D Engine compression testing is important to any internal combustion engine. Monitoring an engine's compression from the assembly inception or purchase gives you "baseline" of your engines performance as time and hours go by. Especially if you begin to add performance modifications. Generally...

115 gram = gold spring 95 gram = dull silver spring 80 gram = black spring 65 gram = shiny silver spring 115 - Mikuni Reference Number 730-03030 95 - Mikuni Reference Number 730-03033 80 - Mikuni Reference Number 730-03027-T 65 - Mikuni Reference Number 730-03027

For those newbies out there that was still learning about internal combustion engines, here is information on how a four-stroke engine works. The four stroke engine was first demonstrated by Nikolaus Otto in 1876, hence it is also known as the Otto cycle. The technically correct term is...

For those newbies out there that was still learning about internal combustion engines, here is information on how a two-stroke engine works. :arrow: The two-stroke engine consists of only three mobile parts: Piston, connecting rod and crankshaft :idea: The first two-stroke engine was a...

RIDE SMART A RIDERS GUIDE TO PERSONAL WATERCRAFT -------------------------------------------------------------------------------- What is a PWC? The official definition of a personal watercraft varies from state to state, but they are generally recognized as a vessel which uses an...

welcome to the forum

Mixing at 40:1 with a good oil like Amsoil Interceptor will suffice. You should not experience accelerated plug fouling either. I also suggest if you take the oil injection pump out of service, you should loop your oil lines in order to keep the rotary gear in a bath.

Ditto on the above:agree:

I see a full rebuild in your future

NEVER CARRY GASOLINE TANKS IN THE TRUNK OF THE TOW VEHICLE. Preparing to tow safely Drain accumulated water from the boat's bilge. Lower the tongue socket onto the ball on the trailer hitch and lock together securely. Connect trailer lights to towing vehicle and check turn signals...

Trailers and cost feature comparison $ If you "have to have a painted" trailer, at least get one that is powder coated. More material is applied gives for more protection. They are placed in a 400 degree oven for a smooth and hard finish. These trailers are the least inexpensive. $$...

I replaced the 1200cc 2 stroke in my 2000 Yamaha GPR with a Sea-Doo 4-Tec 4 stroke SC motor. runs 80+ with the stock IC

http://www.seadooforum.com/showthread.php?t=5826&highlight=fuel+baffle+repair

http://www.seadooforum.com/showthread.php?t=5826 :)

There is part number 50/50 choke assembly. Follow the rod that connects to both carbs, well, there is a small allen set screw on each carb choke butterfly shaft that connects it to the choke rod. loosen th set screw and the rod will slide out. Choke Cable info...

the carbs on that ski are actually easy. they look intimidating but easy. Trust me. Good idea to change all the fuel lines also Remove the air box, disconnect the fuel lines and cables and carb base screws. Replace the base gaskets too. Air box 657 Motor