Search results

What should compression be?

only 146 hrs on it. The intake preasure is 14.1 before start. I think it is to be around 14.7?? Could it be throttle body????

on water still only 52 mph and 6200 rpm

I have 112-115 psi on all cylinders. I can get it to hit rev limiter on trailer but same problem of hesitation once I let it go back to idle

On water it only reaches 6000 rpm and 52 mpg

IC is good no leaks

it hits rev limiter on hose within 30 seconds of running. But it hesitates to get up to rpm once it gets there i can let off throttle for a second and get right back up to limit. But if i let it idle for about 10 seconds it hesitates again.

intercooler is good no water coming out

when running on trailer i can give it throttle and it hesitates to get up to rev limiter. once it gets there i let off throttle a little bit and it gets right back to it fast. I can keep giving it throttle and it will maintain good response and hit limiter. if i let it go back to idle it...

Thanks for the feed back. Although I already had the dealer replace the motor ($3,500.00 later). I wish I would have known about asking for them to check timing. I'm pretty sure they just wanted to get my money. I will ask them if they did that when I pick up ski. I am getting old motor back so...

when running on trailer i can give it throttle and it hesitates to get up to rev limiter. once it gets there i let off throttle a little bit and it gets right back to it fast. I can keep giving it throttle and it will maintain good response and hit limiter. if i let it go back to idle it...

it was running but hard to start and would not go over 35

I have a 2011 RXTX that has low compression on all 3 cylinders. Dealer says that i need a new engine. Anyone have any ideas?? All three cylinders are around 60psi