Search results

First of all thanks for help getting bike running. On the gauges..... no trim, no speed ohmeter, no fuel....checked fuses on the computer in the front...all are good....checked fuse in electrical box where coil is....it is good.....checked connections on computer in front....pins in good...

Thanks for the help .....New SBT starter and found a 325 cranking amp battery at autozone....still has tight spot...not as bad...got seadoo in the water.....run it for twenty minutes......checked okay....put oil in gas also....ran for a hour....so far so good....

how would you identify an oem starter. have the white one i took off. don't know if oem.

thanks for advice

thanks for advice.

thanks for advice....I'll order new starter from SBT....checking jet pump bearing; atleast lube up..I did grease the bearings with the alimites. I will check and see if oil in the fuel pump pulse cavity. I will go with new starter from SBT, a new battery, and a car battery for trouble...

$ 60 on ebay; said it was oem..... will get one from SBT.... also rebuild old starter...Thanks

still having issues with 97 xp starting. engine sat up all winter and half the summer. Now won't turn over with plugs in. New starter, new solenoid, cables ohmed good, getting 11.8 volts at starter when tring to start. New battery. How many cranking amps should the battery have. I can get it to...

I have a 787 xp . read a few post on hydro locking. ski hasn't seen water for a year. read that if crank seals leak it could fill crank case with oil and make it hard to start. just wondering how to get that oil out. tried everything electrical possible turns over with plugs out. put them in and...

how would I drain the oil from the crankcase without pulling the engine; could I remove the oil pump to get it out ???? or ??? thanks in advance for your help......

Looking for a new engine at a decent price...Thanks

yes sir.......turns over nice and fast...smooth.......I will set up volt meter with gator clips so I can do this and check at the starter while trying to start......How much do you think the voltage drop should be???? I will also ohm the positive cable and the negative cable....I did find and...

Thanks for the reply richardpr.... I'm new to the 787 rotax engine.....could you tell me how to drain the crankcase.....the engine was set up for a year in a garage and hasn't seen the water since.....i'm not to familiar with the lubrication set up....hose going to each side of engine from...

yes sir ....... I had removed the carbs to check them over, engine was sitting up for a year with old gas......this is my first rotary engine.... I'm a diesel mechanic.....I had sprayed fuel/oil mix into the intake and actually got the engine to fire up briefly...3 secs.....so I figured I was...

the battery is brand new....added the electrolyte and trickle charged it for12hrs..all connections good....I didn't ohm the wires though so I will check that.... will check voltage at starter while trying to start..... it turns over really fast with plugs out. Was doing the same thing with...

Acquired this 98 xp....checked compression 150 both cylinders....new starter,battery(12.4v),and solenoid....with the plugs removed, the engine turns over easily and smooth....with the plugs in, the engine won't turn over.....no liquid in cylinders...no resrtiction on impellar.....i'm...

thanks for information very helpful....it was wrong key, got wrong key from seller. he couldn't test, battery was dead. put new key in ,two chirps....hit start button and selonoid engaging...checkwed voltage at pos. on starter....getting power...12volts ...no starrt.....pulling starter.....again...

no chirps when pugging in lanyard, only chirps when trying to start. thanks for the help....

I recently acquired this xp. put new battery in it. only chirps when hitting start button. checked solenoid fuse ..good..tried removing temp.sensor wire from sensor...no luck...tried disconnecting oil reservoir wire from reservoir..no luck...any suggestions appreciated

hi there....I recently acquired a 98 xp, had one years ago.....this one just chirps when I hit the start button. any idea what might have it locked out.....disconnected wire from temp.sensor and oil reservoir...no luck...fuse on solenoid good ..battery good...????? any help appreciated thanks