Search results

Hi All As per picture I am battling to find someone who sells no 19 and 21 , mine is damaged and not making proper connection . Anyone know where to buy or what they did to fix ,see there is a similar thread about this Part no's are its the plug and pins for a seadoo wiring harness into the...

Hi All Some of you may be aware I have been rebuilding my ski, last issue I had was compression,sorted that out not so long ago with new rings. I finally put everything back together,after a few turns of the button my seadoo gti 2002 717 started was running nicely for a a few times for about...

Hi Can someone advise when sealing the 2 bottom pieces of your crank case do you apply sealant on the seals too? Or does it only go around the casing both sides Thanks

Hi All I recently did a bottom end replacement of crank seals and bearing the whole 100 yards Same time I did the top end , I bought new piston and rings standard size as nothing was damaged on cylinder head I bought SBT ones,i was told I only needed to hone the heads which I got an...

Hi All Hoping someone with electrical knowledge on a seadoo gti 2002 717 can assist me with some questions I have . Firstly my motor would not start after rebuilding it , the first thing I looked at was to see if I was getting spark was getting a very small spark . I then turned to my...

Hi All Tried starting my seadoo gti 2002 ski after rebuilding it. Nothing happens when I press the start button? I get the 2 beeps once key is installed so I assume it's seen everything? Battery is good as I charged it up , also put the motor positive and negative on to battery motor turns...

Hi All After a good 6 months of having my seadoo gti 2002 in pieces I have built my motor up everything new . Accept the crank bought a refurbished built up one. Anyway I took out the oil mix pump , decide to go pre mix , I have installed the block off kit as well. The carb has been rebuilt...

Hi All Need some help as putting my motor back in can't find the drawing I made for which water pipes go where , see attached as what I recall with marking 1( flushing one ) this goes to my motor head to the port closest to the carb . No 2 and 3 is for the floats that take water out of the...

Hi All Busy re doing my motor , so currently my jet ski is in pieces , as attached thought now would be a good time to refurbish / paint my underside of my haul . Need some help on the easiest way to do it , it's not leaking so was going to put bond on then spray it. Talking about Bond so far...

Hi All Hoping someone can help , busy rebuilding my seadoo gti 2002 engine 717 type . See attached pictures of my charging coil have I fitted this correctly , the way I see it the cable needs to pull out as it's shown as thi is where it's secured. On the 2nd picture I have adjusted the coil...

Hi All see picture of a new set of pistons I got I, dropped it and manged to take a very small piece of metal of of it how I don't know my question is will this still work or cause damage ? 2nd question 2 rings one is sold and the other is like a L has a grove it it which go where ? my...

Hi all Is there a video or link on how to remove your fuel and oil tank on a gti 2002 model ? Or can someone guide me on what parts need to come off. Currently motor is out waiting on parts to rebuild it . Thanks

Hi All I am new here and just bought my first jet ski , I have a seadoo bombardier 2002 gti . I have taken it out a couple of times, I ran ok , until the last time I took it out. Rode it a little Harder and played in the waves my ski generated. Anyway it stopped and would not start, I took...