Search results

Replaced the rubber boot on the trim sliding block with a new one. Trim is working again. I do notice a clicking noise when at the peak of trimming up before it shuts off. Probably the damage I noticed to the worm gear mating surface with the motor gear. May need to replace worm gear later.

Thanks POPPS, I will try that way to adjust it. I know the nut you are talking about. Tough to see in there though. LOL.

Had to pry the trim motor off worm gear. Replaced it with a new aftermarket motor. Old motor was stuck to the worm gear. Worm gear was a little chewed where it made contact with motor gear. It still mated up to new motor. Aftermarket casing was a little different from original. Not much...

Thanks, mikidymac. The previous owner recently replaced the gray fuel lines and claimed he also rebuilt the carbs with genuine Mikuni parts. He also claimed to be a certified SEADOO technician before. I have no proof of either other than he seemed honest. I have no issues with the GTI's...

I moved this thread from meet and greet to appropriate forum. Hope this is ok. 97 GSX 1) Low power 2) Variable Trim issues 3) Info center gauge inoperative and water has penetrated it. 4) Speedometer inoperative. 5) Issue with steering cable. 98 GTI 1) Fuel gauge inoperative. 2) Hood strut is...

Thanks POPPS, for responding with all the good advice. I will do as you say. Will check compression first on the GSX. I have a new trim motor on order to replace the old rusty motor. I had the trim working for a couple days after I tapped on the motor and replaced the trim switch cover which was...

Hey members, I am all new to PWC and boats in general. I appreciate the forum and all of you. I have a lot of questions and a lot to learn. Thank you for each of your valued time. About a month ago I purchased two older inexpensive Seadoos, a 97 GSX and a 98 GTI. Each has some issues. They came...