Search results

Took the needle valve/seat was 1.5. Thank you Mikidymac!

Thank you, will open it up again to see the number stamped at bottom.

Hi Mikidymac, 1st sorry for misspelling your avatar, was going off memory. You are right the engine is a 717 (not 787), and it is from a 2001 Seadoo GTI. I had the same thought process and did not double up on any gaskets, hence the left over ones. I am now waiting for the 60 psi graduated hand...

The engine is a 787, single carb, genuine Mikuni kit. By fuel pump I am assuming you're referring to the check valves and clear membrane which also replaced.

Sorry, Happy 4th of July to all, should have started with that.

Hey guys, I am in the process of rebuilding the carb following the tutorial from mickydimac but it seems there are extra gaskets, and one of them is considerably thicker than then the rubber ones. Mickydimac didn't appear tonuse the thick one. I jut want to make sure the rubber ones don't get...

Thank you Burtshaver2021, I thought the plastic cap had already been removed since the screw driver slot was visible.

I am trying to rebuild this carb and I am a little confused as to how to take off this hi soeed jet screw. It seems it has a stopper and has a limited range of motion. Please see attached pictures. Thank you in advance.