Search results

Does anyone know the difference from impeller part # 26700984 listed for an 2014 RXP 260 and part # 26700945 listed for an 2014 RXT 260? I'm trying to increase the rpm a bit.

Hi Guys, I have been using the solid stainless wear rings for a while now , however I see the combination plastic and stainless liner styles are much less money. Anyone using these with success? I run a lot of sandy dirty water so it's handy to use stainless for the wear. Thanks

Anyone have a solution to the coils popping up on a 4-Tec ? Also anyone know where you can buy just the silicone seal on the connector to coils ?

I just found this diagnosis chart, maybe it will help some members to a quick resolve or at least steer them in the right direction. Maybe someone could post it as a sticky. \ SEA DOO ENGINE FAULT FINDER SEADOO ENGINE FAULTS FUEL PROBLEMS FOR SALE SEADOO 230 KENT JETSKI BOMBARDIER BOATS PARTS...

I just found this diagnosis chart, maybe it will help some members to a quick resolve or at least steer them in the right direction. Maybe someone could post it as a sticky. SEA DOO ENGINE FAULT FINDER SEADOO ENGINE FAULTS FUEL PROBLEMS FOR SALE SEADOO 230 KENT JETSKI BOMBARDIER BOATS PARTS...

Can someone with a 1503 engine measure the length of the carbon ring boot (just the boot) while it is installed in the machine and report back. Obviously it would need to be at a stage of repair where this is all visible so if you can now or remember when it is open it would be much appreciated.

Anyone using Lithium batteries in their ski? I need to replace the lead acid battery and wouldn't mind saving a little weight, just worried about them melting down and any other problems they might have. Please post your experiences if you have any.

Does anyone add some oil to the bearings in the jet pump on a 2014 RXT 260? I grease mine like they say to but none of the grease is near the bearing once you run it.

I bought a Solas CD15/21 impeller but it has a little too much bite despite it being recommended for the stock engine, is there a way to take a little bite out of it? I need to gain 400 rpm

I have a 260 engine and pump in a custom boat, just had to replace the carbon ring as I am sure it was not setup correct when they installed it. How much pressure should I put on the ring with the bellows? The bellow slides on an aluminum housing so the pressure is easily adjustable to really...